This content is for United Kingdom. Our system has detected that you are from United States. Do you want to set United States as your new country?

SILRES® BS 1316

SILRES® BS 1316 is used undiluted as a water-repellent primer and impregnating agent for normal and reinforced concrete.

SILRES® BS 1316 is a mixture of isomeric octyltrimethoxysilanes with isooctyltrimethoxysilane as main component.


Properties

  • greatly delays chloride and water absorption by concrete
  • reduces loss of concrete due to freeze / thaw action in the presence of de-icing salt
  • high resistance to alkalis
  • good depth of penetration
  • low volatility

After application to the concrete, SILRES® BS 1316 reacts with the atmospheric moisture and pore water in the concrete, thereby generating the active ingredient while liberating alcohol. The active ingredient greatly lowers the water absorbency of the treated concrete, which nevertheless retains a very high degree of water vapour permeability since neither pores nor capillaries are clogged.


SILRES® BS 1316 is recommended as a water-repellent impregnating agent and primer for normal and reinforced concrete for bridges, roads and buildings.

Processing

Liberally apply two coats (wet-on-wet) of the impregnating agent uniformly to the concrete. Two coats are needed to ensure that all of the surface is covered. Do not allow puddles to form.

Apply as usual with a low-pressure airless spray, allowing the impregnating agent to flood over the surface. Perhaps use a roller afterwards to distribute the impregnating agent more evenly.

- Allow fresh concrete at least four weeks (preferably six) to set before impregnating it.
- Remove coarse particles and dust from new, unsoiled surfaces with a brush or compressed air. Use superheated steam to clean weathered surfaces that are heavily soiled with oil, abraded rubber, etc., prior to treatment.
- Only impregnate concrete that has a uniformly dry surface with no damp patches. Should it suddenly start to rain, stop treatment and cover the impregnated areas.

Dilution

SILRES® BS 1316 is normally used undiluted.

Storage

The 'Best use before end' date of each batch is shown on the product label. Storage beyond the date specified on the label does not necessarily mean that the product is no longer usable. In this case however, the properties required for the intended use must be checked for quality assurance reasons.

Sales and support

Wacker Chemicals Ltd.
2 Arlington Square, Downshire Way
Bracknell RG12 1WA
United Kingdom
+44  1344  401 670 (Phone)
Contact

How can we help you?

  • Do you need help in choosing a product or do you require technical support? If so, please contact our experts.
Ask a question

More products

Please choose an application for viewing your product matches.

Order

My media


Go to order form

Sales Contact

Wacker Chemicals Ltd.
2 Arlington Square, Downshire Way
Bracknell RG12 1WA
+44  1344  401 670 (Phone)

My favorites

My products