This content is for Saudi Arabia. Our system has detected that you are from United States. Do you want to set United States as your new country?

This product is not available in Saudi Arabia. Please use the product search or contact us.

SEMICOSIL® 936 UV

SEMICOSIL® 936 UV is an RTV-1 amine cure system that cures on contact with moisture in the air and/or through exposure to high energy ultraviolet light.


Properties

  • Rapid UV acceleration
  • Shadow cure

SEMICOSIL® 936 UV is intended as a protective coating for both rigid and flexible printed circuitry containing conventional or surface mounted devices. The performance of SEMICOSIL® 936 UV is dependent upon many factors, including the application method, the thickness of the layer deposited, the substrate, the curing atmosphere, and the curing cycle. Surface Preparation The surface to be coated should be clean and free of dirt and other contaminants. SEMICOSIL® 936 UV is not recommended for use with acrylic or polycarbonate substrates. Application SEMICOSIL® 936 UV may be applied by dipping, spraying, or brushing. Application equipment may be cleaned using organic solvents such as mineral spirits. All traces of solvent should be removed from application equipment before using SEMICOSIL® 936 UV.

Because SEMICOSIL® 936 UV begins to cure on contact with atmospheric moisture, all containers should be tightly closed in lightproof containers when not in use. Dip tanks should be no more than half full and blanketed with a dry, inert gas such as nitrogen. If a skin should form over the surface it may be removed by careful skimming. Spray equipment and brushes should be washed and wiped clean with organic solvents such as naphtha or mineral spirits after use.

A 5 second exposure with a D bulb at an intensity of 0.7 W/cm2 cures a 2 mil coating in less than one minute. A shorter exposure time can be achieved with achieved with higher intensities. The actual time for a given application should be determined on an individual basis. The adhesion of SEMICOSIL® 936 UV to most substrates can be enhanced by a 30 second to one minute preheat cycle at 60-70 °C before exposure to the UV source.

Storage

The "Best use before end date" of each batch is shown on the Certificate of Analysis. Storage beyond the date specified on the Certificate of Analysis does not necessarily mean that the product is no longer usable. In this case however, the properties required for the intended use must be checked for quality assurance reasons.

Sales and support

Wacker Chemicals Middle East
Dubai Silicon Oasis s/n
0001 Dubai
United Arab Emirates
+971  4  709-9999 (Phone)
+971 4 709-9911  (Fax)
Contact

How can we help you?

  • Do you need help in choosing a product or do you require technical support? If so, please contact our experts.
Ask a question

Would you like a product sample?

You can request a product sample here.

Request sample

More products

There are no comparable products

Order

My media


Go to order form

Sales Contact

Wacker Chemical Corporation
S State Road 4950
Ann Arbor, MI 48108
+1  888  922-5374 (Phone)

My favorites

My products